Nos encontraras en Carroceria , chapa y pintura en ALCALA DE HENARES, POLIGONO LA GARENA( 28806) Calle Argentina 12 Nave 6
Taller
calle argentina 12 nave 6 alcala de henares
The Programmable On-Board Exhaust Remote Control Kit was designed by CAPRISTO to work with the CAPRISTO exhaust valves, which opens and closes exhaust valves on exhaust systems fitted with pressure ports. (Please note that this is a replacement unit in case your CAPRISTO remote becomes defective).
The reason to have exhaust back pressure control is to obtain a better engine torque band and to maintain drive-ability in a wide range of conditions.
Today high performance engines prefer a free flowing exhaust at wide throttle openings and high rpm. At smaller throttle openings and low rpm encountered in traffic, a slight increase in exhaust back pressure, results in better low end torque and a more user friendly engine. This pressure is controlled by one or a set of butterfly valves in the exhaust system.
With this programmable valve control unit the opening and closing points of the exhaust valves can be set to your preferences. The exhaust control unit constantly monitors the back pressure in the exhaust system while driving. Under acceleration the back pressure increases and at a preset pressure the controller opens the exhaust butterflies. This releases the back pressure and increase the exhaust gas flow and horsepower.
Three control modes are available.
The opening and closing points for the first two modes are user programmable within certain safety limits.
The key fob supplied with the kit is a stylish unit with two extra buttons that could be used on other equipment capable of receiving the signals (444Mhz).
An on board self learning function allows you to program more key fobs should the need arise. An added safety feature is a fail safe condition which allows the exhaust valves to go to the open position in case of an electrical or vacuum failure. This prevents engine and or header damage from excessive heat build up.
The supplied wiring harness is already fitted with connectors for the solenoid valve and controller.
The power supply and ground wire are the only wires that need to be ended for your specific application.
This make for an easy and no fuss installation.
Porque nos debes elegir? Llevamos muchos años personalizando coches de alta gama, hemos realizado proyectos incluso sobre coches a estrenar. Sabemos como desmontar y montar un coche en condiciones y dejandolo como venia de origen, tenemos muchisima experiencia. No subcontratamos el trabajo con lo cual todo queda controlado internamente. Tenemos grandes carroceros, los mejores pintores, y eso hace que ese trabajo en grupo, lleve el equilibrio hacia un resultado optimo de reforma.
Hacemos piezas en carbono, fabricamos piezas nuevas, si no ves lo que te gusta en el mercado se puede hacer a medida incluso. Y lo mas importante en un reforma, es que sabemos como ajustar las piezas correctamente. Si tu pieza no ajusta muy bien , la reconstruimos, recuerda que somos fabricantes y no solo montadores, con lo cual siempre hay soluciones. Atarius Concept no tiene ninguna Limitacion. Nunca te diremos que no se puede hacer.
Experto Carroceria
RODRIGO VALENZUELA
Estamos aqui para complacer todos tus sueños, trabajaremos en lograr que tus metas y objetivos se hagan realidad.
Nuestra experiencia en el sector de mas de 10 años, avalan nuestros resultados. Un proyecto de reforma de un vehiculo requiere de un equipo con esa experiencia y estamos aqui para brindarte nuestra ayuda y saber hacer para que lo consigas.
Nos encontraras en Carroceria , chapa y pintura en ALCALA DE HENARES, POLIGONO LA GARENA( 28806) Calle Argentina 12 Nave 6